KrispyGauge

Out of Stock

KrispyGauge is a 52mm round touchscreen CAN bus gauge built for native compatibility with all Haltech Elite and Nexus series ECUs. No custom streams, no adapters — just connect the 4-pin JST cable, power it up, and it reads live engine data straight from the Haltech CAN bus. Fully configurable from your phone or laptop via the built-in WiFi hotspot. Every unit is individually tested on a live Haltech ECU before it ships.

✓ 52mm round touchscreen display
✓ Native Haltech CAN bus — Elite & Nexus series
✓ CAN Keypad emulation — up to 8 buttons
✓ Wireless config via built-in WiFi hotspot
✓ Smart warning system with visual alerts
✓ Over-the-air (OTA) firmware updates
✓ Standard 52mm gauge pod fit
✓ Individually tested on a live Haltech ECU before shipping

NZ$600 inc. GST

NZ Nationwide Shipping NZ Post tracked · Rural delivery surcharge may apply

Local Pickup Titirangi, Auckland — by arrangement

New Zealand only. No international orders at this time.

Questions? Check the Support & Setup Guide

In the Box

What's Included.

Everything you need to get up and running — no sourcing extra hardware.

1× KrispyGauge Unit 52mm round touchscreen CAN bus gauge

1× JST XH 4-Pin CAN Cable JST XH 2.54mm pitch · open-ended tails for loom integration

1× 120Ω Termination Resistor For CAN bus network termination — use only if required

1× Retaining Bracket & Hardware Designed for dashboards 5–10mm thick

1× Dashboard Spacer Fit behind the bracket if your dashboard is less than 5mm thick

KRISPYGAUGE

KrispyGauge

What's Included.